Modelización del diodo led, diseño y construcción de la inferfaz del transmisor y receptor para un sistema de comunicación de luz visible mediante un diodo de luz blanca
Para citar o enlazar este item, por favor use el siguiente identificador:
http://dspace.ups.edu.ec/handle/123456789/6871
Título : | Modelización del diodo led, diseño y construcción de la inferfaz del transmisor y receptor para un sistema de comunicación de luz visible mediante un diodo de luz blanca |
Autor : | Peñaherrera Aguilar, Erick Alexander |
Director de Tesis: | Tipán Simbaña, Milton Napoleón |
Resumen traducido: | The purpose of this paper is to design the intensity modulator for SISO and MISO system, for which a SISO system was implemented by modulation on and off by visible light, making a point to point link. LED characterization was performed to find the best working condition. In Part transmitter emitting diode white light (Light Emitting Diode, LED), low power, and the receiver is a photodiode used. Besides the implementation of a circuit for a MISO system, this simulates the conditions encountered when using LEDs and allows a multilevel signal by guiding means. The implementation for the systems was performed in the FPGA (Field Programmable Gate Array) board Cyclone III. Testing and analysis of results for the SISO system is performed by transmitting a frame of random bits at a rate of 10Kbps, and the MISO system is transmitted at a rate of 10Mbps, the results were displayed within the oscilloscope which was proven system performance since the receiver recover the transmitted bits. |
Resumen : | La finalidad del trabajo es diseñar el modulador de intensidad para un sistema SISO y MISO. Se implementó un sistema SISO por modulación de encendido y apagado por luz visible, realizando un enlace punto a punto. Se realizó la caracterización del diodo LED para encontrar las mejores condiciones de trabajo. En la parte del transmisor se utilizó un diodo emisor de luz blanca (Light Emitting Diode, LED), de baja potencia y para el receptor un fotodiodo. Se realizó la implementación de un circuito para un sistema MISO, el cual simula las condiciones que se presentan al utilizar diodos LED y permite obtener una señal multinivel a través de un medio guiado. La implementación para los sistemas se realizó en la tarjeta FPGA (Field Programmable Gate Array) Cyclone III. Las pruebas y análisis de resultados para el sistema SISO se realizaron transmitiendo una trama de bits aleatoria a una velocidad de 10Kbps y para el sistema MISO se transmitió a una velocidad de 10Mbps, los datos transmitidos fueron visualizados en el osciloscopio para comprobar el adecuado funcionamiento de los sistemas. |
Palabras clave : | INGENIERÍA ELECTRÓNICA ANÁLISIS DE SISTEMAS DIODOS SISTEMA DE TRANSMISIÓN DE DATOS MODULADOR |
Fecha de publicación : | may-2014 |
URI : | https://dspace.ups.edu.ec/handle/123456789/6871 |
Idioma: | spa |
Pertenece a las colecciones: | Grado |
Ficheros en este ítem:
Fichero | Descripción | Tamaño | Formato | |
---|---|---|---|---|
UPS - ST001155.pdf | Texto completo | 4,26 MB | Adobe PDF | Visualizar/Abrir |
Este ítem está sujeto a una licencia Creative Commons Licencia Creative Commons